Catalogue
Fixtures
Six brass exterior fixtures in Antique Bronze, all IP65, all 9–17 V AC/DC on a low-voltage circuit. Every one takes a separate lamp, so beam angle, output and colour rendering are chosen per position rather than fixed at the housing. Specifications and drawings below are transcribed from the manufacturer’s sheet for each fixture and confirmed against the physical unit, and each figure is sourced on its page. In-ground, step and deck fittings are in assessment and are not released. Product photography of the physical samples is pending.
Selecting an uplight
Housing length
All four uplights take the same aim and the same circuit. Length sets cut-off. LT2101 at 125.4 mm where the fixture sits behind planting and out of view; SD-08 at 157.4 mm for a heavier housing at the base of mature trees; LT2108 at 180.5 mm where the fixture is between the viewer and the lit surface and the source must stay hidden.
Lamp size
Three uplights take MR16 and deliver 450 lm at 5 W with the LT1016A. SD-03 takes the smaller MR11 at 180 lm and 2.5 W. Specify SD-03 for low shrubs, grasses and shallow beds, where an MR16 housing would overlight the subject and sit too tall in the planting.
Beam
Beam angle belongs to the lamp, not the fixture, so a single housing covers narrow accent work through to a wider wash. Send the drawing and we will return a lamp schedule against it rather than a single beam angle for the whole job.
Specifying a project
Send drawings and we will return a fixture schedule with beam angles, mounting details and load calculations.